Sika MonoTop®-610

Min. 6 months from date of production if stored properly

Store properly in undamaged original sealed packaging, in dry cool conditions between +5°C and +35°C. Protect from direct sunlight, heat and moisture.

~1.15 kg/l

Sika MonoTop®-610 is a part of Sika MonoTop® system comprising of:

20 – 22%

About 1.0 – 1.1 litres of clean water per 5 kg bag

~2.15 kg/l

Bonding primer - sufficient to coat the concrete surface in a thin layer filling pores and voids.

Reinforcement corrosion protection - 2 mm minimum thickness

+6°C minimum; +40°C maximum

~30 minutes at +27°C/ 65% r.H

Apply concrete repair mortar 'wet on wet' with bonding primer.

Apply concrete repair mortar 'wet on dry' with reinforcement corrosion protection coating.

As bonding primer: 1.5 – 2.0 kg/m² (depending on the substrate roughness)

As reinforcement protection: ~2.0 kg/m²/coat per 1 mm layer thickness (2 layers are required)

5 kg of powder yields approximately 2.8 litres

Sika MonoTop®-610 can be mixed with a low speed (≤500 rpm) hand drill mixer or by hand for small quantities.

Pour the recommended water quantity in a suitable mixing container. Add the powder to the water and mix thoroughly to obtain the consistency of cement paste, usually for at least 3 minutes.

Bonding Primer:

Thoroughly pre-wet the prepared substrate a recommended 2 hours before application. Keep the surface wet and do not allow to dry. Before application remove excess water e.g. with a clean sponge. The surface should appear as a dark matt appearance without glistening. Surface pores and voids shall not contain water. Using a suitable clean brush, roller or spraying equipment, cover the substrate in a thin layer filling all pits and voids.

Reinforcement Corrosion Protection:

Using a suitable clean brush or spraying equipment apply a first coat to cover the whole exposed circumference of the reinforcement bars approximately 1 mm thick. When first coat is hard to the finger nail, apply a second coat approximately 1 mm thick. If using a spray method, protect substrate from excessive over-spray. Wait until completely dry before applying repair mortar.

As reinforcement corrosion protection: protect fresh coating immediately from premature drying and contamination using an appropriate curing method.

Clean all tools and application equipment with water immediately after use. Hardened material can only be mechanically removed.